Справочник Пользователя для RAD Data comm IPmux-1E
Chapter 3 Operation
IPmux-1/1E Installation and Operation Manual
3-4 Operating Instructions
Table 3-2. IPmux-1E (BRI/FXS) System Indicators and Switches (Cont.)
No. Name
Type Function
4
ETH LINK
LED
On: Line OK
Off: Link not active
Off: Link not active
5
ETH ACT
LED
On: Frame being transferred on line
Off: No activity
Off: No activity
6 ETH
100M
LED
On: 100 Mbps
Off: 10 Mbps
7
ETH FDX
LED
On: Full duplex
Off: Half duplex
Off: Half duplex
8
POWER
Switch Turns IPmux-1E power ON and OFF
3.2 Operating
Instructions
Turning IPmux-1/1E On
Without Control Terminal
The IPmux-1/1E power switch is located on the back panel, as shown in
Figure 3-2.
➤
To power up IPmux-1/1E without a Control terminal:
1. Turn the power supply switch, located on the rear panel, to ON.
2. Check the unit LED indicators, located on the left side of the front panel, and
1. Turn the power supply switch, located on the rear panel, to ON.
2. Check the unit LED indicators, located on the left side of the front panel, and
the module indicators for proper operation (see Figure 3-1, Figure 3-2,
Figure 3-3, Figure 3-4, Table 3-1, and Table 3-2).
With Control Terminal
➤
To power up IPmux-1/1E with a Control terminal:
1. Make sure all IPmux-1/1E cables and connectors are properly connected.
2. Connect IPmux-1/1E to a PC equipped with an ASCII terminal-emulation
1. Make sure all IPmux-1/1E cables and connectors are properly connected.
2. Connect IPmux-1/1E to a PC equipped with an ASCII terminal-emulation
application (for example, Windows 95 Hyper Terminal or Procomm).
3. Turn on the control-terminal PC and set its default port parameters to
19,200 baud, 8 bits/character, 1 stop bit, No Parity. Set the terminal emulator
to ANSI VT100 emulation (for optimal view of system menus).
to ANSI VT100 emulation (for optimal view of system menus).
4. Switch ON the POWER supply switch, located on the rear panel.
5. When the initialization and self-test are over, a menu appears displaying
5. When the initialization and self-test are over, a menu appears displaying
initialization and self-test results. If the self-test is successful, the RDY LED
(Figure 3-1 and Figure 3-3) on the left side of the front panel lights. If problems
(Figure 3-1 and Figure 3-3) on the left side of the front panel lights. If problems
are encountered, refer to Chapter 4 for instructions.
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com