Справочник Пользователя для RAD Data comm IPmux-1E

Appendix B Telnet

IPmux-1/1E Installation and Operation Manual

B-2

Using Telnet to Manage the IPmux-1/1E

Figure B-1. Telnet Logon Dialog

Telnet Operation

Telnet and ASCII terminal cannot be active at the same time.
If a terminal is active, a Telnet session cannot be established.

➤

To establish a Telnet session:
• Exit the terminal by selecting Exit in the Main menu.

If the auto-disconnect is ON, the terminal will be disconnected
automatically after 15–30 minutes if no characters were sent (see the ASCII

terminal Configuration Menu – Appendix E).
Terminal management has priority over Telnet, if a Telnet session is active

and a user logs on to the terminal, the Telnet session will be disconnected
and the terminal will be the active form of management.

Parameters set to default values via Telnet will not erase the Host and
Default Gateway parameters, to prevent a loss of connectivity.

When configured to default values from the terminal, Host and Default Gateway

parameters will be optionally erased. The user can configure to default parameters

and then decide to keep/erase the Host and Default Gateway.

System Security

A user name and password is required to log on and initiate a Telnet session.
• The Terminal session exits to the password screen and the Telnet session

disconnects after 15 to 30 minutes of inactivity.

The inactivity time-out feature may be deactivated via the ASCII Terminal

Configuration window.
Main Menu

⇒

Configuration

⇒

General Configuration

⇒

ASCII Terminal

Configurations, menu line 4: 15 Minute Timeout)

Note

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610