Справочник Пользователя для Renesas PCA7759
( 3 / 8 )
5. Usage (see Figure 2)
The PCA7759 is connected between an emulation probe or emulator and package converter. According to the converter
you use, the pin numbers of an MCU allocated to CN1 and CN2. For details on pin correspondence, see 7. Correspondence
of Connectors CN1 and CN2 (pages 4 to 8).
you use, the pin numbers of an MCU allocated to CN1 and CN2. For details on pin correspondence, see 7. Correspondence
of Connectors CN1 and CN2 (pages 4 to 8).
Figure 3 Usage of the PCA7759
M30800T-CPE etc.
Package converters
- M30800T-PTC
- M3T-FLX-144NSD
- M3T-FLX-144NSE
- M3T-F160-100NSD
- M3T-F160-128NRD, etc.
- M30800T-PTC
- M3T-FLX-144NSD
- M3T-FLX-144NSE
- M3T-F160-100NSD
- M3T-F160-128NRD, etc.
PC4701 emulator
MCU signal measurement board
PCA7759 (this product)
PCA7759 (this product)
Target system
CN1
CN2
CN1
CN2
PC7501 emulator
Compact emulator
Emulation probe
- M30830T-EPB
- M30700T-EPB
- M3062PT-EPB, etc.
- M30830T-EPB
- M30700T-EPB
- M3062PT-EPB, etc.
M3T-FLX160-PRB
6. Precautions
CAUTION
Cautions to Be Taken for This Product:
• When you remove the PCA7759, be sure to remove it carefully. Otherwise the connector may be
damaged.
• Do not use a screw driver or the like to remove the PCA7759. Otherwise the pattern on a board may be
damaged.
• We cannot accept any request for repair.
• If there is any question or doubt about this product or this instruction manual, contact the following.
Renesas Tools Homepage http://www.renesas.com/en/tools
NOTE: To remove the PCA7759, be sure not to use any
tools. Using a screwdriver may cause a damage of the
pattern on a board.
tools. Using a screwdriver may cause a damage of the
pattern on a board.