Справочник Пользователя для Renesas M30100T3-RPD-E

If you have purchased this emulation pod newly, it is necessary to download the firmware. The
download procedure is given in Figure 2.2.

Before attempting to download the firmware, check the emulator debugger is installed and the
emulator is connected to the host machine. For more information, see each user's manual of the
emulator debugger and the PC4701.

To confirm that your emulation pod works properly, execute the self-check after downloading the
firmware. The self-check procedure is given in Figure 2.3.

See "4.2 Downloading Firmware"
(page 34).

See "3.4 Connecting the PC4701
and Emulation Pod" (page 27) and
"3.5 Connecting the Pod Probe"
(page 29).

Quit the emulator debugger and shut down the PC4701.

Download the firmware using the emulator debugger.

Connect the PC4701 and this product and pod probe.

Within 2 seconds of turning the power ON, press the
RESET button of the PC4701 and check the maintenance
mode is accessed.

See "4.3 Self-check" (page 35).

Within 2 seconds of turning the power ON, press the
system reset switch of the PC4701 and check it is in
maintenance mode.

Push the system reset switch of the PC4701 again to start
the self-check.

After about 40 seconds, check that the self-check is
complete normally and shut off the PC4701.