Справочник Пользователя для Renesas M30100T3-RPD-E
( 27 / 52 )
3.4 Connecting the PC4701 and Emulation Pod
To connect the emulation pod to the PC4701, use the FLX120-RPD 120-pin flexible cable included
in this product package.
in this product package.
(1) Connecting the Cable to the PC4701
Figure 3.7 shows how to connect the PC4701 and FLX120-RPD. To connect the FLX120-RPD, be
sure to hold the both sides of the PC4701 side connector horizontally with the "UPSIDE" facing up.
Then secure with screws.
sure to hold the both sides of the PC4701 side connector horizontally with the "UPSIDE" facing up.
Then secure with screws.
Figure 3.7 Connecting the PC4701 and FLX120-RPD
CAUTION
Note on Connecting the Cable:
• Before connecting the FLX120-RPD, always shut OFF power before connecting the
cable. The power ON state could destroy internal circuits.
Note on Securing the Screws:
• After connecting the emulator main unit to the FLX120-RPD, be sure to secure the
screws.
3.3 Jumper Switches JP1 and JP2 on the M30100T-PRT Board
The jumper switches JP1 and JP2 on the M30100T-PRT board are set to "CSP" side and "0ns" side
respectively when shipped from factory. When there is no instruction in the user's manual of your pod
probe, set these switch to the default.
respectively when shipped from factory. When there is no instruction in the user's manual of your pod
probe, set these switch to the default.
CAUTION
Note on Setting Switches:
• Always shut OFF power when changing the settings of the jumper switches.