Справочник Пользователя для IBM PG-FP3
CHAPTER 8 ERROR MESSAGES AND REMEDIAL ACTIONS
User's Manual U13502EJ2V0UM00
90
Error No.
Message
Cause/action
Cause
IIC communication error
ER3D
IIC READ error. (ACK)
Action
Check the target microcontroller.
Cause
The area set with TYPE setting does not exist.
ER3E
Illegal select AREA.
Action
Check the area information in the TYPE settings.
Cause
An abnormal condition was detected in the internal RAM of the PG-
FP3.
ER40
CPU RAM error.
Action
The PG-FP3 may be damaged.
Cause
An abnormal condition was detected in the expansion RAM of the
PG-FP3.
ER41
Expansion RAM error.
Action
The PG-FP3 may be damaged.
Cause
The POWER SELECT switch is V
DD
OUT but USER V
DD
is supplied.
ER42
Illegal SW Target ON.
Action
Do not supply power (V
DD
) from the target when the POWER
SELECT switch is V
DD
OUT.
Cause
The POWER SELECT switch is USER V
DD
but USER V
DD
is not
supplied.
ER43
Illegal SW Target OFF.
Action
Supply power (V
DD
) from the target when the POWER SELECT
switch is USER V
DD
.
Cause
The target system is not connected.
ER44
Target is closed.
Action
Check the connection of the target system.
Cause
The SCK pin does not go high.
ER45
IIC SCLK is Low level.
Action
Check the SCK pin of the target system.
Cause
An excess V
PP
current was detected.
ER50
VPP OUT CURRENT error.
Action
Check the V
PP
pin of the target system.
Cause
An excess V
DD
current was detected.
ER51
VDD OUT CURRENT error.
Action
Check the V
DD
pin of the target system.
Cause
An excess V
CC
(+5 V) current was detected.
ER52
VCC (+5V) CURRENT error.
Action
The PG-FP3 may be damaged.
Cause
An excess EPROM V
PP
current was detected.
ER53
EPROM VPP CURRENT error.
Action
Check the master PROM. Alternatively, Flashpro3 may be
damaged.
Cause
The target system voltage is abnormal.
ER54
User VDD error.
Action
Check the voltage of the target system.
Cause
The specified area is not blank.
ER5B
Blank check.. Failed AREA
Action
Erase the specified area with the Erase command.
Cause
The specified area cannot be erased.
ER5C
ROM Erase.. Failed AREA
Action
The specified area may be damaged.
Cause
A verify error was detected in the specified area.
ER5D
Verify error. AREA
Action
Erase the area with the Erase command, and reexecute writing.
Cause
Excessive erasing was detected in the specified area.
ER5E
Device error. AREA
Action
The microcontroller may be damaged.
Cause
A pre-write error was detected in the specified area.
ER5F
Erase setting error. AREA
Action
The microcontroller may be damaged.