Справочник Пользователя для Mitsubishi Electronics Q64TCTTBWN

277

CHAPTER 5 SETTINGS AND THE PROCEDURE BEFORE OPERATION

5.2  Settings and the Pr

oce
dure bef

ore Operat

ion

  

The following figure shows the procedure before operating the Q64TCN.

When using the Q64TCTTN and the Q64TCTTBWN which use the thermocouples as the temperature sensors, temperature 
compensation must be executed properly. Perform warm-up operation about 15 minutes before starting operation.

Start

Operation

Mounting the module
  Mount the Q64TCN in a slot.

Wiring
  Wire external devices to the Q64TCN.

Switch setting
  Configure settings using GX Works2.

Execution of auto tuning
  Configure auto tuning to set PID constants.

Execution of auto tuning
  Configure auto tuning to set PID constants.

Configure the initial setting?

Initial setting
  Configure the initial setting using GX Works2.

Auto refresh setting
  Configure the auto refresh setting using GX Works2.

Programming
  Create and check a program without using 
  the FROM/TO instructions.

Warmup operation
  (when the Q64TCTTN or the Q64TCTTBWIN is used)
  Configure warmup operation about 15 minutes before 
  starting operation.

YES

NO

Configure the initial setting 

and the auto refresh setting using 

GX Works2?

YES

NO

Configure 

the auto refresh setting?

YES

NO

Programming
  Create and check a program without using 
  the FROM/TO instructions.

Initial setting
  Create a sequence program for writing initial values 
  using the FROM/TO instructions.

Configure the initial setting?

YES

NO