Справочник Пользователя для Mitsubishi Electronics Q64TCTTBWN
387
APPENDICES
A
Appendix 4 On
line Module Chan
ge Pr
ocedure
(When Using GX D
eveloper
)
Appendix 4.2 Conditions
for onlin
e module cha
nge
Appendix 4.2
Conditions for online module change
To perform an online module change, a CPU module, a MELSECNET/H remote I/O module, the Q64TCN, GX
Developer, and a base unit as listed below are required.
Developer, and a base unit as listed below are required.
Remark
The Q64TCN with the function version C supports the online module change since it was first released.
(1) CPU module
A Process CPU or Redundant CPU is required.
For the precautions on the multiple CPU system configuration, refer to the following.
For the precautions on the multiple CPU system configuration, refer to the following.
QCPU User's Manual (Multiple CPU System)
For the precautions on the redundant system configuration, refer to the following.
QnPRHCPU User's Manual (Redundant System)
(2) MELSECNET/H remote I/O module
A module with function version D or later is required.
(3) GX Developer
GX Developer version 7.10L or later is required.
To perform an online change on a remote I/O station, GX Developer version 8.17T or later is required.
To perform an online change on a remote I/O station, GX Developer version 8.17T or later is required.
(4) Base unit
• When a slim type main base unit (Q3SB) is used, an online module change cannot be performed.
• When an extension base unit (Q5B) that does not require the power supply module is used, an online
• When an extension base unit (Q5B) that does not require the power supply module is used, an online
module change cannot be performed for modules on all the base units connected.
(5) Buffer memory areas that can be saved and restored
The following table lists the buffer memory areas that can be saved and restored.
Buffer memory area name
Buffer memory address
Reference
CH1
CH2
CH3
CH4
CH Input range
Un\G32
Un\G64
Un\G96
Un\G128
CH Stop mode setting
Un\G33
Un\G65
Un\G97
Un\G129
CH Set value (SV) setting
Un\G34
Un\G66
Un\G98
Un\G130
CH Proportional band (P) setting
Un\G35
Un\G67
Un\G99
Un\G131
CH Integral time (I) setting
Un\G36
Un\G68
Un\G100
Un\G132
CH Derivative time (D) setting
Un\G37
Un\G69
Un\G101
Un\G133
CH Alert set value 1
Un\G38
Un\G70
Un\G102
Un\G134
CH Alert set value 2
Un\G39
Un\G71
Un\G103
Un\G135
CH Alert set value 3
Un\G40
Un\G72
Un\G104
Un\G136
CH Alert set value 4
Un\G41
Un\G73
Un\G105
Un\G137
CH Upper limit output limiter
Un\G42
Un\G74
Un\G106
Un\G138
CH Lower limit output limiter
Un\G43
Un\G75
Un\G107
Un\G139
CH Output variation limiter setting
Un\G44
Un\G76
Un\G108
Un\G140