Справочник Пользователя для Mitsubishi Electronics Q64TCRTBWN
56
3.3.3
Details of output signals
(1) Setting/operation mode instruction (Yn1)
Use this signal to select the setting mode or the operation mode.
• OFF: Setting mode
• ON: Operation mode
• ON: Operation mode
Some buffer memory areas can be set only in the setting mode.
(a) Buffer memory areas that can be set only in the setting mode
The following settings can be changed only when Setting/operation mode instruction (Yn1) is off. If the settings
are changed in the operation mode, a write data error (error code: 3
are changed in the operation mode, a write data error (error code: 3
H
) occurs.
Buffer memory area name
Buffer memory address
Reference
CH1
CH2
CH3
CH4
CH Input range
Un\G32
Un\G64
Un\G96
Un\G128
Resolution of the manipulated value for
output with another analog module
output with another analog module
Un\G181
CH Alert 1 mode setting
Un\G192
Un\G208
Un\G224
Un\G240
CH Alert 2 mode setting
Un\G193
Un\G209
Un\G225
Un\G241
CH Alert 3 mode setting
Un\G194
Un\G210
Un\G226
Un\G242
CH Alert 4 mode setting
Un\G195
Un\G211
Un\G227
Un\G243
CT CT selection
Un\G272 to Un\G279 (set for each current sensor (CT))
CH Sensor two-point correction offset
value (measured value)
value (measured value)
Un\G544
Un\G576
Un\G608
Un\G640
CH Sensor two-point correction offset
value (corrected value)
value (corrected value)
Un\G545
Un\G577
Un\G609
Un\G641
CH Sensor two-point correction gain
value (measured value)
value (measured value)
Un\G546
Un\G578
Un\G610
Un\G642
CH Sensor two-point correction gain
value (corrected value)
value (corrected value)
Un\G547
Un\G579
Un\G611
Un\G643
CH Sensor two-point correction offset
latch request
latch request
Un\G548
Un\G580
Un\G612
Un\G644
CH Sensor two-point correction gain
latch request
latch request
Un\G550
Un\G582
Un\G614
Un\G646
CH Number of moving averaging
Un\G698
Un\G699
Un\G700
Un\G701
Cooling method setting
Un\G719
CH Process value (PV) scaling function
enable/disable setting
enable/disable setting
Un\G725
Un\G741
Un\G757
Un\G773
CH Process value (PV) scaling lower
limit value
limit value
Un\G726
Un\G742
Un\G758
Un\G774
CH Process value (PV) scaling upper
limit value
limit value
Un\G727
Un\G743
Un\G759
Un\G775
CH Derivative action selection
Un\G729
Un\G745
Un\G761
Un\G777
CH Simultaneous temperature rise
group setting
group setting
Un\G730
Un\G746
Un\G762
Un\G778
CH Setting change rate limiter unit time
setting
setting
Un\G735
Un\G751
Un\G767
Un\G783
Peak current suppression control group
setting
setting
Un\G784
Sensor correction function selection
Un\G785