Справочник Пользователя для Mitsubishi Electronics DX-VS1

DX-VS1UE User

DX-VS1UE User

DX-VS1UE User

DX-VS1UE User’’’’s Manual

s Manual

s Manual

s Manual

22

Administrator can set transmission conditions, image resolution, and file name. The setting method

of image resolution, filename, and transmission conditions of FTP is the same as that of e-mail.

This page is used to select the serial port for connectiing with a pan/tilt/zoom camera and to set

pan/tilt/zoom functions such as ‘Mode’, ‘Preset’, etc.

It is to select a serial port among Serial#2, and Serial#3 with which a Pan/tilt/zoom control receiver

is connected to DX-VS1UE. Serial#2 are RS232-C interfaces and Serial#3 is RS-422/RS485 inter-

face.

This menu is used to identify the base addresses (camera ID or camera Number) between DX-

VS1UE and a Pan/tilt/zoom camera. Administrator can connect pan/tilt/zoom camera through ana-

logue pan/tilt/zoom controller.

When RS485 is chosen as an interface and two or more Pan/tilt/zoom cameras are connected, it is

necessary to set Camera ID to each camera and to set it to the base address(Camera ID) to which

DX-VS1UE corresponds.

! DX-VS1UE can send e-mail once per five minutes at most in case administrator

set DX-VS1UE  to send e-mail periodically. If there were no restriction in
sending e-mail, DX-VS1UE might cause a serious problem to the recipient’s
mail server. However, there is no limit in e-mail transmission triggered by mo-
tion detection event or sensor event.

! There is no limit.in the FTP funcion. If you set 0 to the periodic sending menu,

DX-VS1UE transmits files at best performance.

! Regarding the FTP function, if the interval between two events is within 2 sec-

onds, the second event may be neglected. If the second event occurs within 3
seconds after image transmission, the second image file is not transmitted at
times.

! Regarding the e-mail function, if the interval between two events is within 3 sec-

onds, the second image file is not transmitted at times.