Справочник Пользователя для Acer R300

45

Installing SCSI hard disks

Note: Before you install a SCSI hard disk in your system, you need 
to install a SCSI controller card. The SCSI controller card shown in 
the illustration below is for your reference only. The actual system 
may not be bundled with a SCSI adapter card. 
For more instructions on how to install a SCSI card to your system, 
refer to page 39. 

To install two SCSI hard disks:

1

Remove the system cover.  See “Removing the system cover” on 
page 35 for more information.

2

Configure the jumper settings, SCSI ID and terminators. 

Note: Refer to the SCSI hard disk documentation for more 
information. 

3

Install the SCSI hard disks to your system following the instruction 
on page 43.  

4

Locate the SCSI controller card on the mainboard.

5

Remove the fan blower. See page 39 step 2 for more information.

Note: If you want to connect more than one SCSI hard disks in a 
daisy-chain fashion, you may need a SCSI terminator. SCSI 
terminators are usually installed at the end of the SCSI cables to 
let fast signals be passed without distortion. 

6

Plug one end of the SCSI cable to the SCSI controller card 
connector (1).

Route the cable along the side of the mainboard and air baffle. 
Connect the second SCSI cable to the first SCSI hard disk connector 
(2). 

Connect the last SCSI cable to the SCSI hard disk connector (3) then 
attach a terminator to the end of the SCSI cable (4). 

aa r300.book  Page 45  Tuesday, March 4, 2003  9:39 AM