Справочник Пользователя для Cyclades 5000
AlterPath Manager E2000, 2500, 5000 Quick Start Guide
4
Figure 7:
Single Network Setup
T
To Set up a Private Network
1. Connect an Ethernet cable from the “Eth1” port on the AlterPath Manager to a hub or switch
that is connected to your public Ethernet LAN. Refer to the “Private Network Setup” diagram
that follows.
that follows.
2. Connect an Ethernet cable from the “Eth2” port on the AlterPath Manager to a hub or switch
that is connected to your private (or managed) Ethernet LAN. Refer to the “Private Network
Setup” diagram that follows.
Setup” diagram that follows.
3. Connect the Ethernet ports of any KVM/net, ACS, TS, or OnSite to a hub or switch that is
connected to the private Ethernet LAN.
4. Set up the other AlterPath devices in the normal manner. Refer to the documentation for the
other AlterPath devices as required.
Figure 8 shows a typical connection setup for a private network. This the most secure setup
because the only path to devices on the private LAN is through the APM.
because the only path to devices on the private LAN is through the APM.