Справочник Пользователя для Multi-Tech Systems RF550VPN
Chapter 5 – Configuring the RF550VPN
13
5 – Configuring the RF550VPN
About the Browser Interface
Initial configuration is required in order for you to begin operation. The browser-
based interface eases VPN configuration and management.
based interface eases VPN configuration and management.
About IPSec
The VPN functionality is based on the IPSec protocol and uses 168-bit Triple DES
(3DES) encryption to ensure that your information remains private.
(3DES) encryption to ensure that your information remains private.
Start the RF550VPN Configuration
1. Connect your workstation.
Be sure your workstation is connected to one of the RF550VPN’s LAN ports.
2. Apply power.
Apply power to the RF550VPN RouteFinder and allow the LEDs to stabilize on
the unit.
the unit.
3. Set the workstation IP address.
The directions for setting your workstation IP address are covered in Chapter 3.
4. Open a Web browser.
·
At the Web browser’s address line, type the RF550VPN IP address
(http://192.168.2.1 (This is the default address of your RouteFinder).
(http://192.168.2.1 (This is the default address of your RouteFinder).
·
Press Enter.
Note:
Make sure your PC’s address is on the same network as the router’s address.
WINIPCONFIG
and
IPCONFIG
are tools for finding out a PC’s IP configuration: the default
gateway and the MAC address. In Windows 95/98/Me, type
WINIPCONFIG
. In Windows
2000/NT, type
IPCONFIG
.