Справочник Пользователя для National Instruments BridgeVIEW
Chapter 11
Loops and Charts
11-24
© National Instruments Corporation
run of the VI. Therefore, you could get a maximum output value that
is not related to the current set of collected data.
is not related to the current set of collected data.
Max & Min function (Functions»Comparison)—Takes two numeric
inputs and outputs the maximum value of the two in the top right
corner and the minimum of the two in the bottom right corner. Because
you only are interested in the maximum value for this exercise, wire
only the maximum output and ignore the minimum output.
inputs and outputs the maximum value of the two in the top right
corner and the minimum of the two in the bottom right corner. Because
you only are interested in the maximum value for this exercise, wire
only the maximum output and ignore the minimum output.
6.
Wire the terminals as shown. If the Maximum Value terminal were
inside the For Loop, you would see it continuously updated, but
because it is outside the loop, it contains only the last calculated
maximum.
inside the For Loop, you would see it continuously updated, but
because it is outside the loop, it contains only the last calculated
maximum.
Note
Updating indicators each time a loop iterates is time-consuming and you should
try to avoid it when possible to increase execution speed.
try to avoid it when possible to increase execution speed.
7.
Run the VI.
8.
Save the VI as
Calculate Max.vi
in the
BridgeVIEW\Activity
directory.
End of Activity 11-7.