Справочник Пользователя для ALTINEX TNP151

400-0434-005

9

Step 1. Cut an opening into the table’s surface. 

Refer to the ALTINEX website at 

for table cutout 

requirements.

Note: The table can be 2.25”  or  less in 
thickness. Always confirm dimensions 
before cutting to insure that specifications 
have not changed. 

Step 2. Insert  the Tilt ‘N Plug Jr. into the table 

cutout. 

Step 3. Place the support brackets under the 

table  in  between the support mount 
grooves on the side of the Tilt ‘N Plug Jr. 
(See Diagram 5 for details.) Attach the 
brackets to the groove at the desired 
height and secure them to the bottom of 
the table using the thumb

screws 

provided.

Step 4. Secure the cables by using the provided 

cable clamps and screws included with 
the unit. Pass the power cord from the 
bottom of the housing and attach it to the 
table using the cable clamp and screw 
supplied with the Tilt ‘N Plug Jr.

Leave enough slack in the service loop to 
allow for easy opening and closing, but 
not too much as to cause excess 
drooping of the service loop.

Step  5. Connect the appropriate cables with the 

correct input connectors on the bottom of 
the unit. 

Step 6. Once you have applied power and 

connected the proper cables on the 
bottom of the unit you may raise the unit. 
To raise the Tilt ‘N Plug Jr. into position, 
push down on the front of the top cover; 
the latching mechanism will then release, 
allowing the pneumatic spring to raise it 
into position.

Step 7. To lower the unit, push on the top of the 

Tilt ‘N Plug Jr. until it locks into place.

The  Tilt ‘N Plug Jr. supplied was carefully tested 
and no problems were detected. However, we 
would like to offer the following suggestions:

•

Please make sure that the highest quality 
network cables are used. 

•

Make sure that no cable or power cord is 
damaged or pinched. If there has been 
damage, do not use the Tilt ‘N Plug Jr. Please 
call the ALTINEX Customer Service Department 
at (714) 990-2300 to have the unit repaired. 

•

If the unit does not rise into position correctly, 
check the service loops for the signal and power 
cords on the bottom of the unit.