Справочник Пользователя для PC Concepts ADSL2+

z

 

Message forwarding based on the Internet Group Management Protocol (IGMP, not 

configurable). 

The System Mode page enables you to configure system-level operating modes that use 

bridging in addition or instead of routing protocols. You can also configure a feature in which 

the mode is selected automatically at start-up, based on the type of Internet connection 

detected on the LAN PC(s).   

 

The current system mode is shown on the System View page that displays when you 

access the configuration program.   The system mode is not configured using a single setting. 

Rather, it is determined at system startup based on whether the device's LAN and WAN 

interfaces are configured with IP information (i.e., are "IP-enabled"), and whether the Bridging 

setting on the System Mode page is enabled or disabled.    

z

 

When the Bridging setting on the System Mode page is disabled, then the system mode 

will display as "Routing". 

z

  When the Bridging setting is enabled and at least one LAN or WAN interface is 

IP-enabled, then the system mode will display as "Routing and Bridging."   

z

 

When the Bridging setting is enabled and no interfaces are IP enabled, then the device is 

considered to be in Bridging Mode. Note, however, that in this case you would not be 

able to access Configuration Manager; without being IP-enabled, the Ethernet interface 

could not communicate using the Internet protocol HTTP, which is used to display 

information in your Web browser.