Справочник Пользователя для Dynalink RTA1046VW

Chapter 4: Web Configuration 

                                                                                                                                                                                       

Quick Start 

The pages under the Quick Start menu provide user a quick way to set up the IAD. If 
you do not know much about the router, you can use the Quick Start pages to adjust 
basic settings to activate your IAD. 

This is a quick way to connect to the 
Internet by using PPPoE interface, 
please click Connect to Internet to 
open the web page. 

Enter the user name and password 
(that you get from the ISP) for your 
Wireless IAD and click Connect. 

The system will connect automatically, 
and then you can access the Internet. 

The quick setup wizard will guide you 
to configure this IAD through some 
specific steps. Yet different connection 
interface will lead to different setting 
pages. Refer to the following pages for 
detailed information. 

Auto Scan Internet Connection 
(PVC):  
If there is no any PVC configured in 
your IAD, you can check this item. 
Otherwise, please uncheck this box.   

VPI (Virtual Path Identifier):  
Identifies the virtual path between 
endpoints in an ATM network. The 
valid range is from 0 to 255. To enter 
the setting, please refer to the setting 
that the ISP offered. 

VCI (Virtual Channel Identifier): 
Identifies the virtual channel endpoints 
in an ATM network. The valid range is 
from 32 to 65535 (1 to 31 is reserved 
for well-known protocols). To enter the 
setting, please refer to the setting that 
the ISP gave you. 

After entering the VPI/VCI value, 
please click Next for the following 
step.