Справочник Пользователя для Dynalink RTA1046VW

Wireless IAD User Manual 

 

On the Configure LAN side Settings 
page; you have to fill in the data 
requested. 

Primary IP Address & Subnet Mask:
Key in the information offered by your 
ISP for the LAN connection, e.g., 
192.168.1.1 for primary IP address 
and 255.255.255.0 for subnet mask. 

MTU:   
(Please refer to the PPPoA/ PPPoE 
section.) The default MTU setting is 
1500. You may modify it if necessary. 

Configure the secondary IP 
Address and Subnet Mask:   
Check this box to set up a secondary 
IP address to connect to your IAD if 
they are not included in the range that 
DHCP server accepts. You have to 
key in the information received from 
your ISP for the LAN connection, e.g., 
the secondary IP is 10.3.80.81 and the 
mask is 255.255.255.248 in the 
example illustrated in the figure. 

DHCP Server On:   
Check this item if DHCP service is 
needed on the LAN side. The IAD will 
assign IP address and gateway 
address for each of your PCs. 

Start IP Address & End IP Address: 
Enter the information needed. 

Key in the duration for the time. The 
default is 1 day. 

DHCP Server Off:   
Check this item if DHCP service is not 
needed on the LAN.   

The primary IP address and subnet 
mask will be shown on it. You can 
modify them if needed. 

                     

   

Key in all the necessary settings. 
Click Next for the coming page. 

You can check the settings on the 
Summary page.   

If you find anything incorrect, click 
Back to modify the settings.   

If everything is OK, click Finish to 
accept these settings.   

And the following page will appear. 

Now, the system will reboot to activate 
the new settings that you have set in 
this section. 

Please wait for 2 minutes before 
restarting the IAD.