Справочник Пользователя для Enterasys Networks E1 Series
General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-79
Command Mode
Read-Only.
Examples
This example shows how to display a summary of information about neighboring Cisco devices
detected on Matrix port ge.0.4. In this case, a device is connected at the neighboring device’s
module 2, port 1 link:
detected on Matrix port ge.0.4. In this case, a device is connected at the neighboring device’s
module 2, port 1 link:
3.2.6.11 set port ciscodp status
Use this command to set the status of the Cisco Discovery Protocol on one or more ports.
set port ciscodp status port-string {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show port ciscodp neighborinfo ge.0.4
Sysname Platform Port ID
----------------------------------------------------------------
ge.0.4 ggismysysname WS-C6509 2/1
NOTE: The Cisco Discovery Protocol must be globally enabled using the set ciscodp
status command as described in
status command as described in
before operational status can be set
on individual ports.
port-string
Specifies the port(s) on which status will be set. For a
detailed description of possible port-string values, refer to
detailed description of possible port-string values, refer to
.
disable | enable
Sets the port status as:
•
disabled - will not transmit or detect neighbors
•
enabled - will transmit and will detect neighbors