Справочник Пользователя для Enterasys Networks E1 Series
General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-82
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to assign priority 7 to untrusted traffic from port ge.0.5:
3.2.6.14 set port ciscodp vvid
Use this command to set the voice VLAN ID for a Cisco DP port. This instructs the IP phone device
connected to this port how to tag voice traffic.
connected to this port how to tag voice traffic.
set port ciscodp vvid port-string {vlan-id | none | dot1p | untagged}
port-string
Specifies the port(s) on which to set a CoS value. For a
detailed description of possible port-string values, refer to
detailed description of possible port-string values, refer to
classify-value
Assigns a Class of Service to untrusted traffic. Valid values
are 0 - 7, with 0 given the lowest priority.
are 0 - 7, with 0 given the lowest priority.
There is a one-to-one correlation between this classify-value
and the 802.1p value assigned to ingressed traffic by the
Cisco IP phone. A classify-value of 0 equates to an 802.1p
priority of 0, which is given lower priority than an 802.1p
priority of 7. Therefore, a classify-value of 7 is given the
highest priority.
and the 802.1p value assigned to ingressed traffic by the
Cisco IP phone. A classify-value of 0 equates to an 802.1p
priority of 0, which is given lower priority than an 802.1p
priority of 7. Therefore, a classify-value of 7 is given the
highest priority.
undefined
No CoS value is communicated to the Cisco IP phone.
Matrix>set port ciscodp cos-ext ge.0.5 7