Справочник Пользователя для Enterasys Networks E1 Series
About This Guide
Welcome to the Enterasys Networks Matrix E1 (1G58x-09 and 1H582-xx) Configuration Guide.
This manual explains how to access the devices’ Command Line Interface (CLI) and how to use it
to configure the Matrix E1 1G58x-09 and 1H582-xx switch/router devices.
This manual explains how to access the devices’ Command Line Interface (CLI) and how to use it
to configure the Matrix E1 1G58x-09 and 1H582-xx switch/router devices.
USING THIS GUIDE
A general working knowledge of basic network operations and an understanding of CLI
management applications is helpful before configuring the Matrix E1 device.
management applications is helpful before configuring the Matrix E1 device.
This manual describes how to do the following:
•
Access the Matrix E1 CLI
•
Use CLI commands to perform network management and device configuration operations
•
Establish and manage Virtual Local Area Networks (VLANs)
•
Establish and manage priority classification
•
Configuring Convergence End Points (CEP) IP telephony detection
•
Configure IP routing and routing protocols, including RIP versions 1 and 2, OSPF, DVMRP and
VRRP
VRRP
•
Establish and manage security, including 802.1x authentication, MAC authentication, MAC
locking, port web authentication, ACLs, DoS prevention and Flow Setup Throttling (FST).
locking, port web authentication, ACLs, DoS prevention and Flow Setup Throttling (FST).
Important Notice
Depending on the firmware version used in the Matrix E1 device, some features described in this
document may not be supported. Refer to the Release Notes shipped with the Matrix E1 device to
determine which features are supported.
document may not be supported. Refer to the Release Notes shipped with the Matrix E1 device to
determine which features are supported.