Справочник Пользователя для Enterasys Networks E1 Series
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-41
Example
This example shows how to display the port priority for Fast Ethernet front panel port 3:
6.2.2.6
set spantree portpri
Use this command to set a port’s priority for use in the Spanning Tree algorithm (STA).
set spantree portpri port-string priority [sid]
Syntax Description
Command Defaults
If sid is not specified, SID
0
will be assumed.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the priority of Fast Ethernet front panel port 3 to 240:
Matrix>show spantree portpri fe.0.3
port priority = 128 for port fe.0.3
NOTE: Path cost (set spantree portcost) takes precedence over port priority.
port-string
Specifies the port(s) for which to set Spanning Tree port
priority. For a detailed description of possible port-string
values, refer to
priority. For a detailed description of possible port-string
values, refer to
.
priority
Specifies a number that represents the priority of a link in
a Spanning Tree bridge. Valid values are from 0 to 240
(in increments of 16) with 0 indicating high priority and
240, low priority.
a Spanning Tree bridge. Valid values are from 0 to 240
(in increments of 16) with 0 indicating high priority and
240, low priority.
sid
(Optional) Sets port priority for specific a SID.
Matrix>set spantree portpri fe.0.3 240