Справочник Пользователя для Enterasys Networks E1 Series
1-1
1
Introduction
This chapter provides an overview of the tasks that may be accomplished using the Matrix E1
1G58x-09 and 1H582-xx CLI interface, an introduction to in-band and out-of-band network
management, and information on how to contact Enterasys Networks for technical support.
1G58x-09 and 1H582-xx CLI interface, an introduction to in-band and out-of-band network
management, and information on how to contact Enterasys Networks for technical support.
1.1
OVERVIEW
Enterasys Networks’ Matrix E1 CLI interface allows you to perform a variety of network
management tasks, including the following:
management tasks, including the following:
•
Assign IP address and subnet mask.
•
Select a default gateway.
•
Assign a login password to the device for additional security.
•
Download a new firmware image.
•
Designate which network management workstations receive SNMP traps from the device.
•
View device, interface, and RMON statistics.
•
Manage configuration files.
•
Assign ports to operate in the standard or full duplex mode.
•
Configure ports to perform load sharing using trunking and link aggregation commands.
•
Control the number of received broadcasts that are switched to the other interfaces.
•
Set flow control on a port-by-port basis.
•
Configure ports to prioritize incoming frames at Layer 2, Layer 3, and Layer 4.
Important Notice
Depending on the firmware version used in the Matrix E1 1G58x-09 or 1H582-xx device, some
features described in this document may not be supported. Refer to the Release Notes shipped
with the Matrix E1 device to determine which features are supported.
features described in this document may not be supported. Refer to the Release Notes shipped
with the Matrix E1 device to determine which features are supported.