Справочник Пользователя для Enterasys Networks E1 Series
VLAN Configuration Command Set
Enabling/Disabling GVRP (GARP VLAN Registration Protocol)
7-48
7.3.8.4
set garp timer
Use this command to adjust the values of the join, leave, and leaveall timers.
set garp timer {[join timer_value] [leave timer_value] [leaveall timer_value]}
port-string
port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the GARP join timer value to 100 centiseconds for all the ports on
all the VLANs:
all the VLANs:
NOTE: The setting of these timers is critical and should only be changed by personnel
familiar with the 802.1Q standards documentation, which is not supplied with this
device.
familiar with the 802.1Q standards documentation, which is not supplied with this
device.
join timer_value
Sets the GARP join timer in centiseconds (Refer to 802.1Q
standard.)
standard.)
leave timer_value
Sets the GARP leave timer in centiseconds (Refer to
802.1Q standard.)
802.1Q standard.)
leaveall
timer_value
timer_value
Sets the GARP leaveall timer in centiseconds (Refer to
802.1Q standard.)
802.1Q standard.)
port-string
Specifies the port(s) on which to configure GARP timer
settings. For a detailed description of possible port-string
values, refer to
settings. For a detailed description of possible port-string
values, refer to
.
Matrix>set garp timer join 100