Справочник Пользователя для Enterasys Networks E1 Series
Connecting to a Console Port for Local Management
Connecting to a Modem
2-5
3. Connect the RJ45-to-DB25 adapter to the communications port on the modem.
4. Turn on the modem and configure your VT emulation package with the following parameters:
5. When these parameters are set, the Matrix E1 startup screen will display.
2.1.4.1
Configuring the Modem to Not Send Login Requests
If the modem attempts to auto-connect or sends requests to the console port, the console port will
treat these actions as login requests, and will fail the login and lockout the console session as a
result.The modem should be configured to not send requests to the console port when attached.
Suggested settings are below. Often, there is a set of dip-switches on the bottom of the modem that
can be adjusted, as in the following example:
treat these actions as login requests, and will fail the login and lockout the console session as a
result.The modem should be configured to not send requests to the console port when attached.
Suggested settings are below. Often, there is a set of dip-switches on the bottom of the modem that
can be adjusted, as in the following example:
Parameter
Setting
Mode
7 Bit Control
Transmit
Transmit=9600
Bits Parity
8 Bits, No Parity
Stop Bit
1 Stop Bit
Switch
Setting
Action
1
on
DTR always on
2
off
Verbal result codes
3
off
Suppress result codes
4
off
Echo offline commands
5
off
Auto answer ring
6
on
Carrier detect override
7
off
Display all result codes
8
off
Disable AT command set
9
off
Disconnect with +++
10
on
Load $FO settings