Справочник Пользователя для Enterasys Networks E1 Series
Port Priority and Classification Configuration Commands
Configuring Port Traffic Rate Limiting
9-37
Example
This example shows how to:
•
globally enable rate limiting on the device,
•
configure rate limiting on port priority 5 for Fast Ethernet front panel ports 3 through 7 to a
threshold of 20,000 bits per second,
threshold of 20,000 bits per second,
•
discard all frames, and enable rate limiting with these parameters on the specified ports:
9.3.6.3
clear port ratelimit
Use this command to reset rate limiting parameters back to default values for one or more priorities
on one or more ports.
on one or more ports.
clear port ratelimit port-string {priority}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>set port ratelimit enable
Matrix>set port ratelimit fe.0.3-7 5 200000 discard enable
port-string
Specifies a port on which to reset the rate limiting
threshold and other parameters. For a detailed
description of possible port-string values, refer to
threshold and other parameters. For a detailed
description of possible port-string values, refer to
.
priority
Specifies the 802.1D port priority level associated with
the port-string on which to reset rate limiting. Valid
values are:
the port-string on which to reset rate limiting. Valid
values are:
•
0 - 7, with 0 specifying the lowest priority, and
•
all to reset the rate limiting threshold and other
parameters on all port priority levels associated with
the port-string.
parameters on all port priority levels associated with
the port-string.