Справочник Пользователя для Enterasys Networks E1 Series

Use this command to display a hop-by-hop path through an IP network from the device to a 
specific destination host when operating in switch mode. Three UDP or ICMP probes will be 
transmitted for each hop between the source and the traceroute destination.

traceroute [-w waittime] [-f first-ttl] [-m max-ttl] [-p port] [-q nqueries] [-s 
src-addr] [-r] [-d] [-t tos] [-F] [-g gateway] [-I] [-n] [-v] [-x] host [packetlen]

-w waittime

(Optional) Specifies time in seconds to wait for a 
response to a probe.

-f first-ttl

(Optional) Specifies the time to live (TTL) of the first 
outgoing probe packet.

-m max-ttl

(Optional) Specifies the maximum time to live (TTL) 
used in outgoing probe packets.

-p port

(Optional) Specifies the base UDP port number used in 
probes.

-q nqueries

(Optional) Specifies the number of probe inquiries.

-s src-addr

(Optional?) Specifies the source IP address to use in 
outgoing probe packets.

(Optional) Bypasses the normal host routing tables.

(Optional) Sets the debug socket option.

-t tos

(Optional) Sets the type of service (TOS) to be used in 
probe packets.

(Optional) Sets the ‘don’t fragment’ bit.

-g gateway

(Optional) Specifies a loose source gateway (up to 8 can 
be specified), or specifies a specific gateway, such as 
gw1.

(Optional) Specifies the use of ICMP echo requests rather 
than UDP datagrams.

(Optional) Displays hop addresses numerically. 
(Supported in a future release.)

(Optional) Displays verbose output, including the size 
and destination of each response.