Справочник Пользователя для Enterasys Networks E1 Series
Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-79
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create CEP detection group 1
:
11.2.6.6 set cep detection type
Use this command to specify whether a phone detection group will use H.323 or Siemens as its
phone discovery type.
phone discovery type.
set cep detection detection-id type {h323 | siemens}
detection-id
Specifies a CEP discovery group ID. Valid values are 1 -
2147483647.
2147483647.
create | delete |
disable | enable
disable | enable
Creates a new convergence end points detection
configuration group, or removes, disables or enables an
existing group. A group must first be created then enabled
to become operational.
configuration group, or removes, disables or enables an
existing group. A group must first be created then enabled
to become operational.
Matrix>set cep detection 1 create
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
detection uses CiscoDP as its discovery method.