Справочник Пользователя для Enterasys Networks E1 Series

The “no” form of this command disables the VRRP session: 

no create vlan vlan_id vrid

Router command.

Router configuration: Matrix>Router(config-router)#

None.

This example shows how to create a VRRP session on VLAN 1 with a VRID of 1:

Use this command to configure a virtual router IP address. If the virtual router IP address is the same 
as the interface (VLAN) address owned by a VRRP router, then the router owning the address 
becomes the master. The master sends an advertisement to all other VRRP routers declaring its 
status and assumes responsibility for forwarding packets associated with its virtual router ID 
(VRID). If the virtual router IP address is not owned by any of the VRRP routers, then the routers 
compare their priorities and the higher priority owner becomes the master. If priority values are the 
same, then the VRRP router with the higher IP address is selected master. For details on using the 
priority command, refer to 

.

address vlan vlan_id vrid ip_address owner 

vlan vlan_id

Specifies the number of the VLAN on which to create a 
VRRP session. This VLAN must be configured for IP 
routing as described in 

Specifies a unique Virtual Router ID (VRID) to associate 
with the routing interface. Valid values are from 1 to 255.

Matrix>Router(config)#router vrrp

Matrix>Router(config-router)#create vlan 1 1