Справочник Пользователя для Fortinet 50B

Go to System > Admin > Administrators.

Select the Change Password icon for the admin administrator.

Enter the new password and enter it again to confirm.

Select OK.

Go to System > Network > Interface.

Select the edit icon for an interface.

Set the addressing mode for the interface.
Choose from manual, DHCP, or PPPoE.

Complete the addressing configuration.
• For manual addressing, enter the IP address and netmask for the interface.
• For DHCP addressing, select DHCP and any required settings.
• For PPPoE addressing, select PPPoE, and enter the username and password 

and any other required settings.

For information about how to configure these and other interface settings, see the 
FortiGate online help or the 

Select OK.

Repeat this procedure for each interface.

Go to System > Network > Options.

Enter the IP address of the primary DNS server.

Enter the IP address of the secondary DNS server.

Select Apply.

Add a default route to configure where the FortiGate unit sends traffic destined for 
an external network (usually the Internet). Adding the default route also defines 
which interface is connected to an external network. The default route is not 
required if the interface connected to the external network is configured using 
DHCP or PPPoE.

Go to Router > Static.

If the Static Route table contains a default route (IP and Mask set to 0.0.0.0), 
select the Delete icon to delete this route.

Select Create New.

Note:  If you change the IP address of the interface you are connecting to, you must 
connect through a web browser again using the new address. Browse to https:// followed 
by the new IP address of the interface. If the new IP address of the interface is on a 
different subnet, you may have to change the IP address of your computer to the same 
subnet.