Справочник Пользователя для Proxim AP-2000

150

Using the Command Line Interface (CLI)

Set the Multicast Rate (802.11b Only)

[Device-Name]>set wif <index> multrate <1,2,5.5,11

(Mbits/sec)

NOTE

The Distance Between APs must be set before the Multicast Rate.

Enable/Disable Super Mode (802.11a/g only)

[Device-Name]>set wif 3 super <enable/disable>

Enable/Disable Turbo Mode (802.11a/g only)

[Device-Name]>set wif 3 turbo <enable/disable>

NOTE

Super mode must be enabled on the interface before Turbo mode can be enabled.

Set Ethernet Speed and Transmission Mode

[Device-Name]>set etherspeed <value (see below)>
[Device-Name]>reboot 0

Set Interface Management Services

Edit Management IP Access Table

[Device-Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>

Configure Management Ports

[Device-Name]>set snmpifbitmask <(see below)>
[Device-Name]>set httpifbitmask <(see below)>
[Device-Name]>set telifbitmask <(see below)>

Choose from the following values:

Set Communication Ports

[Device-Name]>set httpport <HTTP port number (default is 80)>
[Device-Name]>set telport <Telnet port number (default is 23)>

Ethernet Speed and Transmission Mode

Value

10 Mbits/sec - half duplex

10halfduplex

10 Mbits/sec - full duplex

10fullduplex

10 Mbits/sec - auto duplex

10autoduplex

100 Mbits/sec - half duplex

100halfduplex

100 Mbits/sec - full duplex

100fullduplex

Auto Speed - half duplex

autohalfduplex

Auto Speed - auto duplex

autoautoduplex (default)

Interface bitmask

Description

0 or 2 = disable (all interfaces)

All management channels disabled

1 or 3 = Ethernet only

Ethernet only enabled

4 or 6 = Wireless A only

Wireless A only enabled

8 or 10 = Wireless B only

Wireless B only enabled

12 = Wireless A and Wireless B

Wireless A and Wireless B enabled

13 or 15 = all interfaces

All management channels enabled