Справочник Пользователя для RCA 605

E-DOC-CTC-20051017-0151 v1.0

Local Network Setup

2.1 Wired Ethernet

Local network

The Ethernet ports on the back panel allow you to connect the SpeedTouch™ to an 
existing 10 or 100Base-T Ethernet network or one (or more) computer(s) with an 
installed Ethernet card.

Using the SpeedTouch™ Ethernet switch, you can create a local Ethernet network of 
up to four devices, without needing extra networking devices.

Standard wiring

procedure

Use the yellow Ethernet cable provided to wire your computer's Ethernet port to 
one of the SpeedTouch™'s Ethernet ports.

Ethernet link check

LED indicators allow you to check your Ethernet. See 

for more information.

Device settings

Once you have connected a device, you can personalise its settings.

For more information, see 

Managed Ethernet

switch

Your SpeedTouch™ intelligently switches data between the devices on your LAN, 
using priority queuing to ensure that higher priority messages are delivered first 
and in real time. This feature maximizes your network performance. 

The managed Ethernet switch allows you to configure a Virtual Local Area Network 
(VLAN), group ports or isolate a port, configure secure channel connections, define 
Quality of Service (QoS), and configure port mirroring, allowing monitoring from 
one port to another.

You can configure the managed Ethernet switch manually using CLI (For more 
information, see the SpeedTouch™ CLI Reference Guide) or on the expert Web 
pages (see

).

In the SpeedTouch™ package, a yellow full-wired straight-through RJ-45/
RJ-45 Ethernet cable is included.

The Ethernet cable can also be used to wire an Ethernet port of your 
SpeedTouch™ to any external Ethernet hub or switch.

Please follow the installation instructions supplied with the external hub or 
switch for connections and Ethernet cabling.