Справочник Пользователя для ASUS RX3141

RX3141 User’s Manual

Chapter 5 Router Connection Setup

Figure 5.5. WAN – PPPoE0 Settings

Figure 5.6. WAN – PPPoE1 Settings

3. Configure firewall outbound ACL rules to forward the designated traffic to each intended PPPoE

session. Please refer to section 9.5 “Configuring Outbound ACL Rules” for instructions on setting
up ACL rules. Figure 5.7 and Figure 5.8 show the settings for the two outbound ACL rules – one
specify the destination network using the network address and subnet mask and the other using
the domain name. Only one of the two ACL rules is needed. However, if you intend to use IP
address and the domain name to access the myService network, you’ll need to configure both
rules.

Figure 5.7. WAN – First ACL Rule Settings (using

network address/subnet mask) for Forwarding

Packets to PPPOE1 Session

Figure 5.8. WAN – Second ACL Rule Settings

(using domain name) for Forwarding Packets to

PPPOE1 Session

4. Verify that you have all the rules properly configured as indicated in the “Existing Outbound ACL”

table as shown in Figure 5.9. Note that the third rule is the default outbound ACL rule that allows
all the outbound traffic to go through the firewall. You’ll have to configure this rule (see the default
outbound ACL settings in Figure 5.10) if you had deleted. The third rule is used to forward all the
outbound traffic to PPPoE0 session except those intended for PPPoE1 session.