Справочник Пользователя для ASUS RX3141
Chapter 9. Configuring Firewall/NAT Settings
RX3141 User’s Manual
60
Figure 9.8. Self-Access ACL Configuration Page
9.6.1
Add a Self-Access Rule
To add a Self-Access rule, follow the instructions below:
1. Open the Self-Access Rule configuration page, as shown in Figure 9.8, by double clicking the
Router Setup
Î Self Access ACL menu.
2. Select
“Add New” from the “ID” drop-down list.
3. Set desired action (Allow or Deny) from the “Action” drop-down list.
4. Assign a priority for this rule by selecting a number from the “Move to” drop-down list. Note that
the number indicates the priority of the rule with 1 being the highest. Higher priority rules will be
examined prior to the lower priority rules by the firewall.
examined prior to the lower priority rules by the firewall.
5. Make desired changes to any or all of the following fields: source/destination IP,
source/destination port, protocol, ICMP message type and log. Please see Table 9.3 for
explanation of these fields.
explanation of these fields.
6. Click on the
button to create the new Self-Access rule. The new rule will then be
displayed in the Existing Self-Access ACL list table at the bottom half of the Self-Access ACL
configuration page.
configuration page.
Example
Figure 9.9 shows a sample self-access ACL configuration to allow TCP port 80 traffic (i.e. HTTP traffic) from
any one to RX3141.
any one to RX3141.
Figure 9.9. Self-Access ACL Configuration Example
9.6.2
Modify a Self-Access Rule
To modify a Self-Access rule, follow the instructions below:
1. Open the Self-Access Rule configuration page, as shown in Figure 9.8, by double clicking the
Router Setup
Î Self Access ACL menu.
2. Click on the icon of the Self-Access rule to be modified in the Existing Self-Access ACL table
or select the Self-Access ACL from the ID drop-down list.