Справочник Пользователя для Avaya X330WAN
Chapter 6
X330WAN CLI Commands
124
Avaya X330WAN User’s Guide
loopback remote (Controller context)
Use the
loopback remote
command to ask the device on the far end to put itself
into loopback mode.
Note:
1. This command can only be performed if the controller is set to T1.
2. Use this command during line setup and maintenance.
1. This command can only be performed if the controller is set to T1.
2. Use this command during line setup and maintenance.
Syntax
loopback remote
{line|payload}
Parameters
Example
X330WAN-2DS1-1(config-controller:1)# loopback remote line
no channel group (Controller context)
Use the
no channel group
command to delete a channel group.
Syntax
no channel-group
<channel-num>
Parameters
Example
X330WAN-2DS1-1(config-controller:1)# no channel-group 2
no loopback (Controller context)
Use the
no loopback
command to disable the loopback mode.
Syntax
no loopback
line
The controller loops the external line signal back towards the
network without reframing the DS1 signal.
network without reframing the DS1 signal.
payload
The controller loops the external line signal back towards the
network and reframes the DS1 signal. (This option is available in the
ESF framing mode and only when FDL is defined.)
network and reframes the DS1 signal. (This option is available in the
ESF framing mode and only when FDL is defined.)
channel-num
ID number to identify the channel group. The valid range is from
0 to 23 for T1 lines, and from 0 to 30 for E1 lines.
0 to 23 for T1 lines, and from 0 to 30 for E1 lines.