Справочник Пользователя для Bay Technical Associates 529H

Status.......................................1
Set Serial Port Configuration................2
Set Message Terminate Character..............3
Set Data Block Length........................4
Set Control Character........................5
Set Mode of Operation........................6
Exit.........................................X

Enter Request:

NOTE: "n" shown on the previous page indicates single-digit port
numbers on the 525H and  528H.  The menus of the 5218H will
display nn indicating two-digit port numbers.

By responding to the Enter Request: message at the end of the main
configuration menu (see 

Section 6.1) with "2" (Set Serial Port

Configuration), you may change the configuration of each port (i.e.
baud rate, word size, stop bits, parity and XON/XOFF handshaking). 
Note that each port is configured individually.  The multiport will
respond with:

Enter Port Number (0=Exit),Return:

You should then enter the number of the port that you wish to
reconfigure, followed by 

Carriage Return.  Note that if 0 (zero) is

entered, you will exit back to the main configuration menu.

For example, if you enter "

3" and Carriage Return for Port 3, the

multiport will respond with the current status of Port 3 and a menu of
the available options:

•••••••••••••••••••••••••••••••••••••••••
• Port • Baud • Word • Stop •Parity•Xon/•
•      • Rate • Size • Bits •      •Xoff•
•••••••••••••••••••••••••••••••••••••••••
•  3   • 9600 •  8   •   1  • None • Off•
•••••••••••••••••••••••••••••••••••••••••

Exit/Save..........1  Set stop bits....4
Set baud rate......2  Set parity.......5
Set word size......3  Set Xon/Xoff.....6

Enter request: