Справочник Пользователя для ZyXEL Communications P-660RU-Tx
Chapter 22 Firmware
P-660RU-Tx User’s Guide
153
22.1.3 Firmware and Configuration Files Examples
This section contains examples about managing configuration files and uploading
firmware to your P-660RU-Tx.
firmware to your P-660RU-Tx.
Using FTP to Restore Configuration
This example shows you how to restore a previously saved configuration. Note
that this function erases the current configuration before restoring a previous back
up configuration; please do not attempt to restore unless you have a backup
configuration file stored on disk.
that this function erases the current configuration before restoring a previous back
up configuration; please do not attempt to restore unless you have a backup
configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to
your device since FTP is faster. Please note that you must wait for the system to
automatically restart after the file transfer is complete.
your device since FTP is faster. Please note that you must wait for the system to
automatically restart after the file transfer is complete.
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE your device. When the Restore
Configuration process is complete, the device automatically
restarts.
PERMANENTLY DAMAGE your device. When the Restore
Configuration process is complete, the device automatically
restarts.
Restore Using FTP Session Example
Figure 72 Restore Using FTP Session Example
to read about configurations that disallow
TFTP and FTP over WAN.
FTP and TFTP Firmware and Configuration File Uploads
These examples show you how to upload firmware and configuration files.
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE your device.
PERMANENTLY DAMAGE your device.
FTP is the preferred method for uploading the firmware and configuration. To use
this feature, your computer must have an FTP client. The following sections give
examples of how to upload the firmware and the configuration files.
this feature, your computer must have an FTP client. The following sections give
examples of how to upload the firmware and the configuration files.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit