Справочник Пользователя для Lenovo 70B89000NA
Troubleshooting Routers
If you encounter a problem while connecting or using your ix4-300d, check the topics listed below for
possible solutions.
possible solutions.
If you have properly set port forwarding on your router and remote access still does not work, you may
have multiple routers on your network. In this situation, you will most likely have two NAT (Network
Address Translation) firewalls.
have multiple routers on your network. In this situation, you will most likely have two NAT (Network
Address Translation) firewalls.
1. One of the easiest ways to identify this issue is to log in to the router to which the ix4-300d is
connected.
2. Once you have logged in, go to the page that shows the router's WAN IP address, usually Status
or Network Info.
3. If the WAN IP address begins with 192.168, 10, or 172, you may have a NAT Firewall between
the router and internet connection.
There are several options for resolving double NAT situations. The sections below explore the pros and
cons of each resolution:
cons of each resolution:
These instructions will refer to the router that is connected directly to the internet as the Primary
Router. The cascaded router or router to which your ix4-300d is connected is referred to as the
Secondary Router.
Router. The cascaded router or router to which your ix4-300d is connected is referred to as the
Secondary Router.
●
Use the primary router's DMZ
●
Port forward the primary router to the secondary router
●
Put the secondary router in bridging mode
●
Put the primary router in bridging mode
Enabling the DMZ
Most routers have a feature called DMZ or Default Server. DMZ stands for Demilitarized Zone, Data
Management Zone, Demarcation Done, or Perimeter Network. The DMZ allows you to enter an IP address
that will exist outside the router's NAT Firewall.
Management Zone, Demarcation Done, or Perimeter Network. The DMZ allows you to enter an IP address
that will exist outside the router's NAT Firewall.
This is the easiest way to configure your network to handle double NAT situations; however, it is
dependent upon DMZ functionality within your primary router.
dependent upon DMZ functionality within your primary router.
To enable the DMZ:
1. Log in to the primary router.
2. Navigate to the settings page for DMZ or Default Server. Refer to the documentation that came
with your router for information on where this feature is found.
3. Enter the secondary router's IP address.
4. Save your settings.
Your secondary router is no longer behind your primary router's firewall. If port forwarding is correctly
configured, remote access should now be working properly. Moving your secondary router into the DMZ
should not have any effect on the security of the network, since it is still protected by the secondary
router's firewall.
configured, remote access should now be working properly. Moving your secondary router into the DMZ
should not have any effect on the security of the network, since it is still protected by the secondary
router's firewall.
Hardware Management
124
Troubleshooting Routers