Справочник Пользователя для HP (Hewlett-Packard) E3000/IX

Configuring a Point-to-Point Node

The Point-to-Point Configuration screen (#44) in Figure 7-2 is displayed
when you press the

 key at the Network Transport

Configuration screen (#42) with an NI type of

2

 (Point-to-Point). Refer

Chapter 5 , “Introductory Screens,” for information on the Network
Transport Configuration screen.

Step 1. In the

IP address

field, enter the internet protocol (IP) address for the

node being configured. An example of an address is:

C 192.191.191 009

.

Step 2. The IP subnet mask is optional. If entering one, tab to the

IP subnet

mask

 field and enter the number in the same format as an IP address.

Step 3. Move to the

Link Name

 field. Enter a link name to represent the

Point-to-Point card for which you are configuring a link. This name
must be unique to both the node and the network interface (NI). Up to
40 network links are supported per Point-to-Point (router) NI.
(Up to eight network links are supported per screen. To
configure additional links, save the current screen and then
clear the screen to add additional links.)

Step 4. Tab down to the

Physical Path

 field. Enter the physical path number

corresponding to the SPU slot number of the programmable serial
interface (PSI) card, or slot and part of advanced communication
controller (ACC) card.