Справочник Пользователя для HP (Hewlett-Packard) E3000/IX

Configuring a Gateway Half

The Gatehalf Configuration screen (#40) in Figure 9-2 is displayed
when you press the

 key at the Network Transport

Configuration screen (#42) with an NI type of

5

 (Gateway Half). Refer

to Chapter 5 , “Introductory Screens,” for information on the Network
Transport Configuration screen.

Step 1. In the

Partner’s IP address

 field, enter the internet protocol (IP)

address of this gateway half ’s partner.

Step 2. The IP subnet mask is optional. If entering one, tab down to the next

field. In the IP subnet mask field, enter the number in the same format
as an IP address.

Step 3. Tab to the

Home NI name

field. Enter a name that is the same as one of

the other network interface names of the node being configured (except
gatehalf or loopback networks).

Step 4. Tab down to the

Link name

 field and enter a link name to represent

each individual hardware interface card.

Step 5. Tab over to the

Link type

field. Enter

DD

for direct dial or

DC

for leased

lines, private lines, or other non-switched links.

Step 6. Enter the physical path of this node’s Programmable Serial Interface

(PSI) card.