Справочник Пользователя для Foundry Networks FGS624XGP

Installing the FastIron GS Chassis

September 2007

© 2007 Foundry Networks, Inc.

3 - 13

3.

Mount the device in the rack as illustrated in Figure 3.3.

NOTE:   Although Figure 3.3 shows a device with short mounting brackets, the procedure for securing a 
device with long mounting brackets is the same.

4.

Proceed to “Powering On the System” on page 3-14.

To mount the device on a wall, you must order and install the Wall Mount Bracket kit (part number 70076-000). 

In addition to the Wall Mount Bracket kit, you will need the following tools for installation:

•

#2 Phillips-head screwdriver

•

4  #10 screws (for mounting the Foundry device on a wall)

•

1/2" thick plywood sheet if you are mounting the device on a wallboard and there are no studs on which to 
mount the device.

Follow these instructions to install the brackets and mount the Foundry device on a wall.

1.

Using the screws supplied in the kit, attach the mounting brackets to the sides of the device, as illustrated in