Справочник Пользователя для Fortinet 5103b
Basic Configuration
Factory default settings
FortiController-5103B Session-Aware Load Balancer Guide
10-500-161552-20140822
10-500-161552-20140822
25
To connect to the CLI over an Ethernet network use SSH to connect to the mgmt port
(default IP address 192.168.1.99).
(default IP address 192.168.1.99).
To connect to the CLI using a serial console connection
1 Connect the FortiController-5103B unit’s Console port to the serial communications
(COM) port on your management computer using a serial cable (or using an RS-232 to
USB convertor).
USB convertor).
2 Start the terminal emulation application and configure the following settings.
• Bits per second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
3 Press Enter to connect to the CLI.
4 Type a valid administrator account name (such as admin) and press Enter.
5 Type the password for that administrator account and press Enter. (In its default state,
there is no password for the admin account.)
Factory default settings
The FortiController-5103B unit ships with a factory default configuration. The default
configuration allows you to connect to and use the FortiController-5103B web-based
manager or CLI to configure the FortiController-5103B board.
configuration allows you to connect to and use the FortiController-5103B web-based
manager or CLI to configure the FortiController-5103B board.
To configure the FortiController-5103B board you should add a password for the admin
administrator account, change the management interface IP address, and, if required,
configure the default route for the management interface.
administrator account, change the management interface IP address, and, if required,
configure the default route for the management interface.
Initial session-aware load balanced cluster setup
This section describes how to setup a session-aware load balancing cluster consisting of
a single FortiGate chassis, a FortiController-5103B board, and three FortiGate-5000
workers, similar to the cluster shown in
a single FortiGate chassis, a FortiController-5103B board, and three FortiGate-5000
workers, similar to the cluster shown in
To install the FortiController-5103B board and connect to its web-based manager
1 Insert the FortiController-5103B board into chassis slot 1 using the procedure
.
2 Connect the FortiController-5103B mgmt interface to the network from which you
want to manage the device.
Table 5: FortiController-5103B factory default settings
Administrator Account
User Name: admin
Password: (none)
MGMT IP/Netmask
192.168.1.99/24
At any time during the configuration process, if you run into problems, you can reset the
FortiController-5103B board or the FortiGate-5001B boards to factory default settings
and start over. From the CLI enter execute factory-reset.
FortiController-5103B board or the FortiGate-5001B boards to factory default settings
and start over. From the CLI enter execute factory-reset.