Справочник Пользователя для Barco 101-B

PJWU-101B  17/10/2014

31

5. Getting Started

Press the power switch at the back of the projector to switch on this projector. 
 

-    When ’0’ is pressed, the projector is switched off. 
-    When ’1’ is pressed, the projector is switched on. 
 
The projector starts up in standby.   

When the projector is turned off, it is required to wait for at least 90 seconds to re-start the projector to 
complete the cooling of lamp.

Press 

  key once on the local keypad or   on the remote control.

 

Press 2x power button to go to standby, after first push then push again to power of projector, the message is displayed. 
 
The projector goes to standby.

All custom  settings  are written  to the internal  backup  device.   A message  ’Saving  data ...’ indicates  
this process.  Never switch off the projector while this message is displayed.

When switching to standby, an after cooling process will start to cool down the projector.  The after cool 
time depends on the temperature inside the projector and can vary from 30 second to 5 minutes.

1.  Press first Standby.
2.  Let cool down the projector until the fan speed decreases.  At least 5 minutes.
3.  Switch off the projector with the power switch.  ’0’ must be pressed.

AUTION: Never switch off the projector while the message ’Saving data ... ’ is displayed !