Справочник Пользователя для Sony PX35

7

 GB

Notes on Installation

Over

v

iew

Do not install the projector in the following 
situations. These installations may cause 
malfunction or damage to the projector.

• Allow adequate air circulation to prevent 

internal heat build-up. Do not place the 
unit on surfaces (rugs, blankets, etc.) or 
near materials (curtains, draperies) that 
may block the ventilation holes.

• When the internal heat builds up due to the 

block-up, the temperature sensor will 
function with the message “High temp.! 
Lamp off in 1 min.” The power will be 
turned off automatically after one minute.

• Leave space of more than 30 cm (11 

7

/

8

 

inches) around the unit. 

• Be careful that the ventilation holes may 

inhale tininess such as a piece of paper.

• Avoid installing the unit in a location 

where the temperature or humidity is very 
high, or temperature is very low. 

• To avoid moisture condensation, do not 

install the unit in a location where the 
temperature may rise rapidly.

Avoid installing the unit in a location where 
there is a lot of dust; otherwise, the air filter 
will be obstructed. The dust blocking the air 
through the filter may cause raising the 
internal heat of the projector. Clean it up 
periodically.

When using the projector at an altitude of 
1,500 m or higher, turn on “High
Altitude Mode” in the INSTALL SETTING 
menu.  Failing to set this mode when using 
the projector at high altitudes could have 
adverse effects, such as reducing
the reliability of certain components.