Справочник Пользователя для Epson EB-Z9800W

Check

Remedy

Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?

Point the remote control towards the remote receiver.

s

Is the remote control too far from the projector?

The operating range for the remote control is about 30 m.

s

Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?

Set the projector up in a location where strong light does not shine onto the remote receiver.

Is the correct setting for the remote receiver selected?

Check the remote receiver in the Configuration menu.

s

 Settings - Remote Receiver 

Are the batteries dead or have the batteries been inserted incorrectly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.

s

Do the remote control ID and the projector ID match?

Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all projectors
by remote control regardless of the ID setting, set the [ID] switch on the remote control to Off.

s

Does the Remote Control Type match the remote control that you
are using?

Check the Remote Control Type on the Configuration menu.

s

 Extended - Operation - Advanced - Remote Control Type 

Is the optional remote control cable connected to the projector's
Remote port?

When the remote control cable is connected, the projector's remote receiver is disabled. When not using the remote
control cable set, disconnect it from the Remote port.

Is Control Communications set to On?

The Remote port is disabled. When using the optional remote control cable set, set Control Communications to
Off

.

s

 Extended - HDBaseT - Control Communications 

Is the remote control button lock set?

When the remote control button lock is set, buttons except for those needed for basic remote control operations are
deactivated. Hold down the [Help] button to cancel the remote control button lock.

s