Справочник Пользователя для EIKI LC-XB41N

26

Setting Procedure

Setting procedures and contents differ depending on the LAN installation location.  

When installing, consult your system administrator to set up the LAN appropriately.

Connect the LAN cable to the LAN connection terminal of the projector.

Set the Wired LAN network through the projector menu.

Detailed network settings will be made with browser. Refer to “6. Configurations with

Browser” (pp.39–54).

First, complete the settings described in this chapter before performing steps in “6. Configurations

with Browser.”

1. Turn on the projector and select “Wired” from the input menu of the projector.

The projector’s Link Lamp will be on and the Access Lamp will start to blink. If the “Wired

setting” is “Off”, it will not blink. Follow step 2 and 3 to blink the lamp.

2. Select “Wired Setting” in the projector menu, and press the SELECT button.

Select similar LAN environment among LAN1, 2 and 3 with the Point 7 8 buttons. (LAN1, 2,

and 3 are the factory default setting environments. You can select three different

environment among setting LAN1–3. For each setting, refer to the chart on page 31.)  

When selecting “Off” in the “Wired setting”, the LAN connection will be cut off. Use the

function when disconnecting the projector from the network.

3. Press the Point button then the “Please wait...” message will appear and switching operation

will start. Switching will take a while and after completing the operation, the “Ready for use”

message will appear. During the switching period, the projector cannot be operated.

LAN Cable

LAN Connection

Terminal

Link Lamp (Orange)
Light orange when the
terminal is correctly
connected to the 
Network HUB with 
the LAN cable.

* When the LAN setting is “Off”, the two

lamps will not be on.

Access Lamp (Green)
Blink green when
exchanging data with 
the network.