Справочник Пользователя для EIKI LC-XD25

To the AC outlet.

This  projector  uses  nominal  input  voltages  of  100-120 
V or 200-240 V AC.  This projector automatically selects 
the  correct  input  voltage.    It  is  designed  to  work  with 
single-phase power systems having a grounded neutral 
conductor.  To reduce the risk of electrical shock, do not 
plug into any other type of power system.
Consult your authorized dealer or service station if you 
are not sure of the type of power being supplied.
Connect  the  projector  with  all  peripheral  equipment 
before  turning  the  projector  on.  (See  pages  15-17  for 
connection.) 

Connect the AC power cord (supplied) to the 
projector.

NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.

To power cord 

connector on your 

projector.

Ground

To the AC outlet.

To the AC outlet.

  

The AC outlet must be near this equipment and must be easily 
accessible.

0.39" (10 mm)

Ferrite Core

Keep closing until 

it makes a clicking 

sound.

AC Power Cord

Before  using  the  AC  Power  Cord,  attach  the  ferrite  core 
(supplied)  as  shown  in  the  figure. The  Power  Cord  with 
ferrite core must be used for RF interference suppression.

✔ 

   

Unplug  the  AC  power  cord  when  the  projector  is  not  in  use.  
When  this  projector  is  connected  to  an  outlet  with  the  AC 
power  cord,  it  is  in  Stand-by  mode  and  consumes  a  little 
electric power.