Справочник Пользователя для Infocus IN5554L

Wired Remote Option
If the wireless range of the remote is not sufficient, the remote can be wired 
directly into the projector’s Wired Remote connector.

Setting an ID Code for the Remote and Projector
A unique ID number can be set, pairing both the projector and remote, so that the 
remote will only control the projector it is paired with.

Note: Always press and hold the ID Set button before pressing any other buttons 
on the remote and always release the ID Set button after releasing the other 
buttons.

To review the current ID Code settings: Press and hold the ID Set button on the 
remote for 5-8 seconds. 

If the projector and remote ID codes have never been set, the following message 
displays, “[PJ_ID] X ... [RC_ID] X ... [RC_TBL] 0”. 

PJ_ID refers to the current projector ID number and RC_ID refers to the current 
remote ID number. 

RC_TBL refers to the remote control table and displays 1 if the projector and 
remote are paired or 0 if they are not paired.

Using the “RSE” RS232 command (see “Control commands” on page 47 for 
more information), set the projector ID code. Valid commands are RSE1 
through RSE9. For example, RSE3 sets the projector ID code to “3”.

To verify that the projector ID number has been set correctly, press and hold 
the ID Set button on the remote for 5-8 seconds and verify that the projector 
ID number ([PJ_ID]) displays the number you entered using the RSE command. 
In our example, the following message would display, “[PJ_ID] 3 ... [RC_ID] X ... 
[RC_TBL] 0”. 

To set the remote ID number, press and hold the ID Set button and Menu 
button simultaneously for 5-8 seconds or until the message, “Please press ID 
SET + #”, displays.

While continuing to hold the ID Set button, release the Menu button and 

press the button which corresponds with the projector ID number set in Step 
#1. For example, pressing ID Set and “3” on the remote will set the remote ID 
code to “3”.

Continue holding these buttons until a confirmation message appears. For 
example, if both the projector and remote ID codes are set to “3”successfully, 
the message, “[PJ_ID] 03 ... [RC_ID] 03 ... [RC_TBL] 1” displays. Note: If the 
PJ_ID and RC_ID numbers match, but the RC_TBL displays 0, press and hold the 
ID Set button for an additional 5-8 seconds.

The projector and remote are now paired. Other remotes will not operate this 
projector.

To clear the current ID Code settings: Press and hold the ID Set button and the 
Clear button simultaneously for 5-8 seconds, or until the message “ID Cleared” 
displays. This clears the remote ID number. 

Note: It is not necessary to clear the projector ID number, however if you wish to 
do this, you must reset the projector ID number using the RSE command code 
“RSE255”.

•

Make sure the batteries are installed in the proper orientation and are not 
dead.

•

Make sure you’re pointing the remote at the projector or the screen, not the 
computer, and are within the remote range of 32.8’ (10m) at +/- 30 degrees. 
For best results, point the remote at the projector.