Справочник Пользователя для Infocus IN5554L

It is recommended that you clean the filters every 250 hours (or as needed 
depending on your room environment) and replace the filters at the same time as 
you replace the lamps. Follow the instructions below.

Turn the projector off and unplug the power cord. Wait 60 minutes to allow the 
projector to cool thoroughly. 

Press the release levers on the filter cover (located on the front corner of the 
projector) and swing the cover to remove it. Repeat for the filter cover located 
on the opposite front corner.

Gently pull out each filter, noting the orientation of each. Replace with the new 
filters which come with your replacement lamp modules or vacuum the exist-
ing filters (and the area around the filter covers) carefully. Note: If the filters 
are damaged or heavily soiled, they must be replaced.

Gently re-insert the filters into the filter slots, making sure that the Air Flow 
arrows are pointed towards the projector intake vents. Replace the filter covers 
by aligning the hinges and pressing the covers closed. 

Plug in the power cord, turn on the power switch and press the Power button 
to turn the projector back on. Note: Connection to a circuit with a minimum of 
20A capacity is recommended.

Turn off and 
unplug projector

Wait 60 
minutes

(1)

A

“

A

“

A

A

“

“

(3)

(2)

(4)