Справочник Пользователя для Acer 65PE
English 9
A
B
A
Operation
3
Turn On/Off Procedure
Power on
Press the Standby/On key to turn on the lamp. The LED will blink
green during warm up and then light solid green.
green during warm up and then light solid green.
"INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE" will be displayed on the
screen after the projector has identified the input signal;
screen after the projector has identified the input signal;
“SEARCHING“ message will be displayed on the screen if there is no signal
input;
input;
“SYNC IS OUT OF RANGE” message will be displayed on the screen if the
horizontal frequency of the input signal exceeds the range of the
projector.
horizontal frequency of the input signal exceeds the range of the
projector.
Standby
Press the Standby/On key for more than one second to turn off the
lamp. The LED will then blink orange and the lamp will shut down,
but the fan will continue to run for about
lamp. The LED will then blink orange and the lamp will shut down,
but the fan will continue to run for about
1 minute to cool the
lamp. After the fan stops, the LED will turn to a light solid
orange.
orange.
*Lamp Protection Procedure: If you try to turn on the lamp again while the LED is
blinking, the projector will ignore the command until it has cooled down for one
minutes.
blinking, the projector will ignore the command until it has cooled down for one
minutes.
External Control
Control Pad
Figure 12 External control pad